In the previous article, the manufacturer of Starred-River gear reducer has analyzed the problem of broken teeth and how to maintain the gear of Starred-River gear reducer for everybody, so I will not elaborate on it here. This article mainly analyses the cause of gear wear of Starred-River gear reducer.

Firstly, there are several reasons for the wear of gears.

1. Wear occurs because of oil shortage.

2. The involvement of metal scraps in lubricating oil used for gears will also cause tooth surface wear to a large extent.

3. The manufacturing material of the gear itself does not conform to the operation regulations, so it is easy to cause abnormal wear and tear in the work.

4. There are various kinds of sand holes and air holes in gears, which can cause wear problems.

5. There are problems in heat treatment of gears, or some units do not carry out heat treatment in use.

Then, if the meshing accuracy of the gear and its motion accuracy do not reach the standard, wear will also occur.

Secondly, the measures to solve gear wear need to be carried out from the following aspects:

1. To reduce the roughness of the gear surface, the hardness of the gear surface should be gradually improved.

2. Guarantee the cleanliness of gear running device and lubricating oil, add anti-wear substances in lubricating oil, or add magnets in gear oil tank, use these magnets to absorb the metal particles in lubricating oil, and reduce the metal content, then the wear degree of gear will naturally reduce.

Above is the whole content that the manufacturers of Starred-River gear reducer analyze the cause of gear wear of Starred-River gear reducer and the solution measures, hoping to be helpful to everyone.