There are many cooling methods for the reducer, which requires us to choose different cooling methods according to different actual conditions when carrying out cooling work, so that the cooling effect can be exerted under different usage conditions. So do you know what is the cooling method of the reducer?

The reducer manufacturers share the cooling methods of the planetary gear reducer as follows:
1. Internal cooling of the rotor
In order to make the equipment work under a higher pressure difference, a more effective cooling method can be adopted, that is, the rotor is cooled with circulating oil, and there are oil holes and oil diameter shaft heads at both ends of the pump shaft, and then pass through the inner wall of the rotor from the other end. discharge.

2. Air cooling
The so-called wet reducer means that the air sucked in by the inter-stage or double-stage is compressed and transmitted through the combined muffler with comprehensive absorption and phase difference.





3. Water cooling
The equipment generates heat due to conveying and compressing the gas, which must be dissipated from the rotor to the housing.

4. Oil film cooling of rotor
This cooling method is to connect an oil pipeline at the inlet of the equipment, and use the cooling oil dripped evenly to take away the heat of the rotor.

The reducer should be combined with the actual situation of the operating equipment to select a suitable cooling method in order to achieve a better operating effect. When we operate and use the reducer, the cooling methods for the reducer are mainly those described above. All of us can operate and use our reducer according to the above cooling method.