English
简体中文
русский
These are all customized products according to
customer's requirement. If needed, we can
provide custom sevice for you.
The reducer is a relatively precise machinery. It is to reduce the speed and increase torque. So what are you knowing about the precautions before installing reducer?
The precautions before the reducer manufacturers share the installation reducer are as follows:
1. The use temperature of the reducer is 0 to 40 ° C.
2. This unit should be cleaned before use. And check if the mounting shaft has a trauma, dirt, if it should be cleared.
3. Check if the mating size of the hole (or axis) of the reducing machine meets the requirements, the aperture should be H7 (the tolerance of the shaft is H6).
4. The maximum bit is replaced with an exhaust screw before use to ensure that the gas is discharged at the time of operation.
2. This unit should be cleaned before use. And check if the mounting shaft has a trauma, dirt, if it should be cleared.
3. Check if the mating size of the hole (or axis) of the reducing machine meets the requirements, the aperture should be H7 (the tolerance of the shaft is H6).
4. The maximum bit is replaced with an exhaust screw before use to ensure that the gas is discharged at the time of operation.
The correct installation of the speed reduction is an important part of ensuring normal operation of the machinery. When installing the speed reduction, please use the following installation and use it, carefully assemble and use.
